Best answer: How do you cook a 10 lb lobster?

Is it better to steam or boil lobster?

Boiling is a little quicker and easier to time precisely, and the meat comes out of the shell more readily than when steamed. For recipes that call for fully cooked and picked lobster meat, boiling is the best approach. … In contrast, steaming is more gentle, yielding slightly more tender meat.

How long boil jumbo lobster?

Boil the lobster for 10 minutes for the first 1-lb of weight and then 3 more minutes for each extra pound. A 2-lb lobster will be done in 13 minutes, a 3-lb lobster in 16 minutes. Once cooked, drain the lobster immediately and serve hot with some melted butter on the side for dipping.

Do you cook lobster upside down?

Once you have got a real rolling boil and steam, put the lobsters upside down into the steamer and cover. (For those who prefer the lobster to be dead before cooking, plunge the tip of a sharp knife straight down right behind the lobsters eyes). … Be sure you have steam again before timing 11-13 minutes.

How do you cook lobster so it’s tender?

Baking with water on the bottom of the pan in the oven gently steams the lobster, giving a tender almost poached texture. This works great for larger sized lobster tails that need more time to cook. It takes about 1 to 2 minutes per ounce to fully cook using this method.

How do I know when my lobster is done boiling?

It should be bright red. Using a chef’s knife, split the shell where the tail meets the body. If the meat is white, the lobster is fully cooked. If it’s still translucent, back into the pot it goes.

Is lobster cheaper in Maine?

Soft shell lobsters are abundant during the summer months and they can’t be shipped so they are at a much lower price point than hard shell lobsters. …

Whats the largest lobster you can buy?

Jumbo Lobsters

Ranging in size from 4 to 20 pounds, these lobsters are hard to find and sure to impress.

Do you split lobster tails before boiling?

Use shears or a knife to cut the lobster tail along the middle. You should cut the lobster all the way back to the very tip of the fin. Try to avoid cutting into the meat, so that it does not break apart during the boiling. Instead, keep the shears well above the meat by pulling up on the shell as you cut.

How long do you need to boil lobster?

Clamp the lid back on tightly and return the water to a boil over high heat. Reduce the heat to medium and cook the lobsters for 12 to 18 minutes (hard-shell lobsters will take the longer time), until the shells turn bright red and the tail meat is firm and opaque when checked.

Do you rinse lobster before cooking?

Whether you purchased frozen or fresh lobster tails, you should always first rinse off the tails’ exterior. To ensure the lobsters are clean, scrub the shell only, not the exposed meat. Do not submerge the tails in water as the meat can absorb the liquid, creating a watery tasting lobster.

Why is my lobster rubbery?

Tough or rubbery meat is usually the result of a lobster cooked too long. See our cooking guide for suggested cooking times for live lobster.